EN
How to assemble and use
1.
Place the bottle on the flat surface, with open side facing upwards.
Place ingredients in the bottle. When doing so, make sure you do not
exceed the maximum level (fig. 1).
2.
Close the full bottle by putting the blending tip on. Attach the reversed
bottle to the base of the blender (fig. 2). Insert the plug into the power
socket. Switch the device on by pressing and holding the on/off button.
The device will stop working after you have released the button. The
device will activate only when the bottle with blending tip or other
accessory are properly mounted on the base of the blender.
3.
Remove the bottle from the base of the blender, turn and place on
the flat surface. Remove the blending tip and lock the bottle with
a cap (fig. 3).
4.
Coffee grinder: place the device on a flat surface. Insert the plug into
the power socket. Fill the device with coffee beans and make sure
the grinder has been properly and tightly locked. Place the grinder
on the blender. To start grinding coffee, press the button on the body
of the device.
Tips on use
1.
The bottle may be used also as a water bottle or other cold drinks bottle.
2.
To assure optimal efficiency, it is advisable to place ingredients in the
bottle in the following order: liquids, fresh fruits or vegetables, frozen
yogurt, yogurt, ice-creams.
3. Hard fruits must be cut into pieces not larger than 1,8 x 2,5 cm.
4.
Do not overfill the bottle. When the blender stops working, switch the
device off, unplug, wait for 15 minutes and remove surplus of food.
