ZVconnect User Guide
Step 4:
With
no source
connected to the Transmitter; press the Transmitter’s power
button for 3 seconds to power on Transmitter. LED will turn
purple
while
booting.
Important
: Do not connect a source to the Transmitter during this
synchronization procedure.
While LED is still
purple
; press and hold the center button until the LED
becomes flashing
blue
and then release it. (LED will flash
red
before it starts
flashing
blue
) The Transmitter will now pair with the Receiver. When the pairing
is successful, a “Synchronizing is completed” message will appear in the upper
right corner of the display. The LED on the Transmitter will turn flashing
red
after
this process. Transmitter is now ready, but you must complete step 5 below.
Rev 20230215
Page of
9
27
