ZyPerUHD60
Single LAN Decoder (Rev 1D and 1DA)
The function of the ZyPerUHD60 Decoder is to accept a 1Gb IP feed containing the video
information to be displayed. It decodes and formats the video and audio information for display
on the attached viewing device.
Enclosure
There is one size of the ZyPerUHD60 Lite Decoder unit enclosure.
Ports (Decoder Back)
Input Function
Box Size
HDMI Output
215mm x 120mm x 25mm
Port Name
Index
Definition
Power
A
12VDC from supply. Center Post is + Ring is -
Hardware
Reset
B
Recessed hardware reset pin. Disconnect ZyPerUHD60 from
network and delete unit from within ZyPer Management Platform.
Then, fully power unit, press and hold pin for 10-15 seconds and
the unit will reset to defaults. Reconnect to network and
reconfigure in ZMP.
Ethernet
(PoE)
C
1Gb Ethernet over Cat6 (or better) cabling. RJ45 with PoE.
Important Note:
If using PoE with ZyPerUHD60 units; the
ZyPerUHD60 must have a path to the ground. This grounding
can be accomplished by using a shielded network cable (F/UTP)
or by making sure the ZyPerUHD itself or the connected HDMI
display is grounded. (i.e. A 3-prong power connector on display)
Port Name
Rev: 20231115
Page of
22
77
User Manual
B
A
D
C
E
F
G
H
