ZyPerUHD60
AC Mains Connection
The ZyPerUHD60 Encoder and Decoder units are powered through an external AC/DC
converter unit or via the Ethernet PoE feature.
If PoE is not available, the Encoder and Decoder units must be powered and connected using
an external AC/DC converter. (Available separately) The voltage supplied to the Triple Input
Encoder units from the external supply is 20VDC at 6.0A. All other Encoder and Decoder units,
power from external supply is 12VDC at less than 2.0A.
•
Do not substitute the supplied AC/DC power supply unit with another component.
The overall system compliance is dependent on each of the provided elements
being present and operational.
INFORMATION: The introduction of a foreign, non-ZeeVee element nullifies
any claim of regulatory compliance asserted by ZeeVee.
The AC/DC power supply shall be powered from the appropriately rated AC mains
voltage which allows for a wide range of input, generally from 100VAC through 240VAC.
Only use a power cord with an appropriately rated protective earth connection. The protective
earth connection is essential to the overall safety of the system.
WARNING: Bypassing or omitting the protective earth
connection increases the risk of electrical shock and
radio emissions
Install the equipment in such a manner as the IEC power cord ingress in to the AC/DC adapter
is accessible as this is the boundary of the AC mains system and the point at which the
ZyPerUHD60 equipment is disconnected from the AC mains power if needed.
The equipment should be installed as near as is practicable to an AC outlet.
•
Do not substitute or extend the DC cable from the AC/DC unit.
The ZyPerUHD60 system is intended and rated for continuous operation
Should the ZyPerUHD60 equipment be unused for an extended period of time it should be
disconnected from the AC mains at the AC inlet to the external AC/DC converter in order to
protect the equipment from transient over-voltage conditions.
Rev: 20231115
Page of
65
77
User Manual
