Preparations for use
14-Function Foot Control Panel, Wired or Wireless
Version 6.1
Page 40
G-30-1706-en
Pairing with the stand / FCP upgrade kit (optional)
–
Pairing means the fixed relative assignment of the suspension system and
foot control panel.
It is only necessary for wireless operation.
–
When pairing the system for the first time, it may take up to 20 seconds
until a signal link between the suspension system / FCP upgrade kit and
foot control panel has been established.
•
Switch on the stand.
•
Put the foot control panel in a vertical position (1) in the immediate vicinity
of the device (less than 1 m away).
on the stand
•
Start the pairing on the stand in line with the respective user
instructions of the stand.
•
After starting the pairing process on the stand, wait at least
10 seconds before performing any further steps on the FCP.
on the FCP upgrade kit (optional)
•
Delete the existing pairing by pushing the "Pairing" button (9) on
the FCP upgrade kit for longer than 5 s and hold the button down.
The "Radio link intensity" status indicator (7) on the FCP upgrade
kit will be illuminated in orange. The existing pairing is deleted.
•
Release the "Pairing" button (9) on the FCP upgrade kit.
The "Radio link intensity" status indicator (7) on the FCP upgrade
kit is no longer illuminated.
For FCP WL 2 only
•
Briefly press and release one of the buttons (3) on the FCP.
All four status indicators illuminate briefly.
NOTE!
The foot control panel may be disabled
•
If pairing is performed incorrectly or not at all, the foot control panel may
be disabled or activation of a control may trigger functions on a different
suspension system not assigned to the foot control panel.
Summary of Contents for 304970-9100-000
Page 4: ...14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 4 G 30 1706 en...
Page 76: ...Device data 14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 76 G 30 1706 en...
Page 80: ...Index 14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 80 G 30 1706 en...