Preparations for use
14-Function Foot Control Panel, Wired or Wireless
Version 6.1
Page 44
G-30-1706-en
Plug in connection cable
–
You need the connection cable for the wired operation of the foot control
panel.
–
Pairing is not necessary during wired operation.
Use only
–
cable 304970-8730-000 with a length of 3 m or
–
cable 304970-8735-000 with a length of 3 m and angled plug for S7 stand
or
–
cable 304970-8760-000 with a length of 6 m
NOTE!
Tripping hazard due to loops in the connection cable
•
Check how the connection cable (if available) is laid.
•
Remove loops and lay the connection cable so that there are no tripping
hazards.
NOTE!
Use of systems for microwave ablation
Do not use any systems for microwave ablation in the frequency range
between 2400 and 2480 MHz. These disturb the wireless operation of the
foot control panel.
•
Operate the foot control panel with a connection cable at all times.
NOTE!
Operation of WLAN systems
Systems with WLAN (2.4 GHz band) may disturb the wireless operation of the
foot control panel.
•
Operate the systems with WLAN at a distance of at least one meter from
the foot control panel.
Summary of Contents for 304970-9100-000
Page 4: ...14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 4 G 30 1706 en...
Page 76: ...Device data 14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 76 G 30 1706 en...
Page 80: ...Index 14 Function Foot Control Panel Wired or Wireless Version 6 1 Page 80 G 30 1706 en...