START-UP
Axio Examiner
Installing standard components
Carl Zeiss
M60-2-0003 e 05/2012
35
Setting the easy motion (torque) of the two ergonomic drive pinion knobs
3.1.11.3
The ergonomic drive has been set to a medium easy motion value in the factory. This setting may be
modified as follows.
X axis setting:
•
Remove the additional sleeves (Figure 3-15/
1
and
3
) from the pinion knobs, if any. To do so, unscrew
the clamping screws.
•
Slide the X pinion knob down (Figure 3-15/
5
), and slide the Y pinion knob upwards (Figure 3-15/
7
).
•
Hold the X pinion knob (Figure 3-15/
5
) in position, and turn the light-colored knurled ring
6
) located above either to the right (easy) or to the left (heavy) until the desired easy
motion is obtained.
Y axis setting:
•
Hold the Y pinion knob (Figure 3-15/
7
) in position, and turn the light-colored knurled sleeve
8
) located above either to the right (easy) or to the left (heavy) until the desired easy
motion is obtained.
•
Slide on the additional sleeves if required, and tighten the clamping screws.
To ensure a long useful life for your stage, make certain to remove the wear debris caused by
object slides at regular intervals. When doing so, make certain that the abrasion debris do not enter
the X positioning guide mechanism.
Replacing the universal mounting
3.1.11.4
frame
•
Unscrew the two countersunk head screws
(Figure 3-16/
1
) using an Allen wrench, width
A/F 2 (Figure 3-16/
3
).
•
Lift the universal mounting frame
(Figure 3-16/
2
) up and off the mechanical stage
4
).
•
Put the desired mounting frame or specimen
holder(Figure 3-16/
5
) on the mechanical stage,
and screw it down using the two countersunk
head screws.
Figure 3-16 Replacing the universal mounting
frame
Summary of Contents for Axio Examiner
