OPERATION
Axio Imager
Operating the motorized microscope via the touchscreen of the TFT display
Carl Zeiss
M70-2-0020 e 06/2009
430000-7344-001
123
Instead of fluorescence filter sets, just dyes may be selected. If this is the case, the user would choose the
relevant dye from the subselection options listed.
Fluorescence filter sets can be selected by their numbers. Additionally, a suitable dye may be picked for
each filter set from the submenu.
Once a new reflector has been allocated, the relevant reflector button on the
Microscope
operation
page will show the corresponding information.
Configuring a reflector position, using Colibri
as a source of illumination
Once Colibri has been recognized and configured
as a source of illumination, an appropriate LED can
be selected for each filter set or dye.
•
To do this, press the
Colibri
button.
•
From the following pop-up menu (Fig. 4-64),
pick one or several LEDs matching the reflector
position selected.
•
As an alternative, an optionally installed white-
light source (HXP 120) can be picked as well.
Note that LED and HXP cannot be chosen at the
same time.
•
Acknowledge the selection procedure by
pressing
Save
or press
Cancel
to discard the
selection.
•
Acknowledge the selection procedure a second
time by pressing
Save
or press
Cancel
to
discard the selection.
•
Acknowledge the safety query with
OK
.
Fig. 4-63
Configuring the reflector position
using Colibri
Fig. 4-64
Selecting Colibri / HXP 120
illumination
