OPERATION
Axio Observer
TFT display touchscreen on the Axio Observer 7, 7 materials
ZEISS
12/2016
431004-7244-001
133
(2)
Reflector
This tab is used to configure the reflector turret.
Up to six buttons are displayed, depending on the
actual number of turret positions. The system
detects the number of nosepiece positions during
initialization (and when the
Settings ->
Components
page is opened). Before any
reflectors have been configured, the buttons are
labeled only with the numbers of the turret
positions.
After a reflector has been configured, the
following data is displayed: designation (Type),
reflected light module (RL), transmitted light
position / module (TL)
Once a reflector has been assigned to a
position, the corresponding reflector
button on the
Microscope -> Control
page will be labeled accordingly.
•
Press the relevant button to configure a turret
position.
•
Select the appropriate reflector from the list in
the
Configure reflector position # in
Reflector turret
window. The current selection
is shown in the
Resulting configuration
line.
•
Select
RL
and / or
TL
.
•
Press the
Save
button. If the turret position has
already been configured, a confirmation prompt
will be displayed.
Fig. 123
Settings -> Components -> Reflector
page
Fig. 124
Settings -> Components -> Reflector
-> Configure reflector position # in
Reflector turret page
Summary of Contents for Axio Observer Series
Page 1: ...Axio Observer Inverted microscope Operating manual...
Page 192: ......
