OPERATION
ZEISS
TFT display touchscreen on the Axio Observer 7, 7 materials
Axio Observer
134
431004-7244-001
12/2016
(3)
Focus
On this tab, you can enter the firmware settings for the focus drive. The speed of the focus drive can be
set individually for each objective.
a) Focus speed
Up to six buttons are displayed, depending on the
actual number of turret positions. The system
detects the number of nosepiece positions during
initialization (and when the
Settings ->
Components
page is opened). Before any
objectives have been configured, the buttons are
labeled only with the numbers of the nosepiece
positions.
After an objective is assigned to a specific button,
the magnification appears on the left (blue) half of
the button. The right, gray part of the button
shows the focus speed.
•
To change the focus speed for an objective,
press the respective gray part of the button.
•
The speed can be set between values of 1 and 10 using the
◄►
buttons in the
Focus speed for
objective #
pop-up window. The higher the numerical value, the higher the focus speed in the
selected magnification.
The following factors are recommended for the focus control speed, depending on the objective
magnification.
Objective
magnification
Factors for focus control
speed
Objective
magnification
Factors for focus control
speed
1x
10
20x
6
1.25x
8
40x
5
2.5x
8
50x
4
5x
7
63x
3
10x
7
100x
3
•
Press the
Save
button.
Fig. 125
Settings -> Components -> Focus
page
Summary of Contents for Axio Observer Series
Page 1: ...Axio Observer Inverted microscope Operating manual...
Page 192: ......
