PUTTING THE INSTRUMENT INTO OPERATION
Carl Zeiss
Mounting Standard Components
Axio Vert.A1
56
431030-7044-001
05/2012
3.1.11.4
Installing the VIS-LED Attachment
Lamp
WARNING
Avoid looking directly into the LED
light.
WARNING
Always make sure that the VIS-LED
attachment lamp is switched off when
mounting it onto or dismounting it
from the reflected light port.
•
Loosen the clamping screw (Fig. 3-19/
2
) on the
reflected light port (Fig. 3-19/
1
) and remove the
cap.
•
Insert the attachment lamp (Fig. 3-19/
4
) with
the dovetail ring into the port (Fig. 3-19/
1
). Use
ball-headed screwdriver SW 3 and the locking
screw (Fig. 3-19/
2
) to lock the illuminator firmly
into position.
•
Insert the three-pin illuminator plug
(Fig. 3-19/
3
) into the lower socket (Fig. 3-19/
5
)
for reflected light (
RL
) at the back of the
instrument.
•
Put the
TL
/
RL
switch (Fig. 2-9/
22
) into the
position for reflected light (
RL
).
Adjusting the VIS-LED Attachment Illuminator
•
Switch on the attachment lamp via the
operational microscope. (See Section 1.1.)
•
Switch off the diffusion disk (Fig. 2-9/
26
) and
remove the filter from the light path.
•
Use the
≤
40x objective to focus on a free area
of the specimen.
•
Remove the eyepiece. Use the adjusting screws
(Fig. 3-20/
1
and
2
) to center the image of the
illuminator in the pupil image.
•
Use the focusing screw (Fig. 3-20/
3
) to ensure
an optimized, even illumination of the pupil
image.
•
Switch the diffusion disk on again and insert
the filter.
Fig. 3-19
Attaching the VIS-LED Illuminator
Fig. 3-20
Adjusting the VIS-LED Attachment
Illuminator
Summary of Contents for Axio Vert.A1
Page 1: ...Operating Manual Axio Vert A1 Inverted Microscope ...
Page 106: ......
