START-UP
Axioscope 5/7/Vario
Mounting standard components
ZEISS
03/2018
430035-7344-001
47
3.1.6
Inserting and removing push-and-click (P&C) reflector modules into the reflector
insert
To install or uninstall the modules, the reflector insert (reflector turret with 4 or 6 coded positions,
reflector slider with 2 coded positions) must be removed from the upper part of the stand.
Inserting a module:
•
Remove the reflector insert (
1
) from the
upper part of the stand (section
3.1.7) and put
it aside with the top side facing down.
•
Insert the module (
3
) (with the top side
facing down) with the aid of its mounting
elements on its left and right (
4
) at a
slant from the top into the lower spring clips
(
2
) on the reflector socket.
•
Press the module against the upper spring clips
of the reflector turret until it engages firmly.
Removing a module:
•
Disengage the module from the upper spring elements by tilting it forward, then lift it off the lower
spring elements and remove the module.
•
After installing or uninstalling the reflector module, don’t forget to replace the reflector insert or the
cover cap.
Fig. 3-8
Changing the reflector module in
the reflector insert
