Axioskop 2 FS
plus
START-UP
Axioskop 2 FS
MOT
Initial start-up
Carl Zeiss
B 40-076 e 02/01
2-21
2.1.15
Connect control unit and keypad
to the Axioskop 2 FS
MOT
Focusing of the Axioskop 2 FS
MOT
is performed
exclusively using the motorized z-adjustment of
the objective slider. The high-precision step motor
used for z-adjustment is accommodated in the
stand and operated via a separate control unit
with connected keypad.
Proceed as follows to connect the control unit and
the keypad to the Axioskop 2 FS
MOT
:
•
Connect keypad plug to the
Keypad
socket
(2-27/
2
) at the rear of the control unit.
•
Plug one end of the connecting cable to the
Motor Microscope
socket (2-27/
1
) of the
control unit and the other end to the
Axioskop 2 FS
MOT
interface (2-28/
1
).
Make sure not to mix up the plugs
when you connect the microscope
and the keypad to the control unit.
2.1.16
Switch on/off the control unit of
the Axioskop 2 FS
MOT
•
Switch the control unit and keypad on/off via
the line switch (2-29/
1
).
Fig. 2-27
Control unit (rear)
Fig. 2-28
Axioskop 2 FS
MOT
(rear)
Fig. 2-29
Switch on/off the control unit of
the Axioskop 2 FS
MOT
Summary of Contents for Axioskop 2 FS plus
Page 1: ...Operating Manual Axioskop 2 FS plus FS MOT Research Microscope...
Page 14: ...INTRODUCTION Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT 0 14 B 40 076 e 02 01...
Page 110: ...OPERATION Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT 3 40 B 40 076 e 02 01...
Page 122: ...ANNEX Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT A 2 B 40 076 e 02 01...
