ZEISS
2 Safety | 2.3 Prevention of Hazards
2
.2.2 Safe Operating Condition
If circumstances occur which impair safety and cause changes in operating behavior, the micro-
scope must be shut down immediately and a ZEISS service representative should be informed.
The microscope may only be operated after correct installation by a ZEISS service representative
and if the operating conditions are adhered to.
§
§
§
Do not operate the microscope until you have completely read and understood the entire
documentation.
Make sure that all protective cover panels are installed and all warning labels are available and
legible.
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
2
.3 Prevention of Hazards
This section summarizes potential hazards and recommended safety precautions. Failure to follow
the safety instructions and instructions may result in personal injury and property damage.
2
.3.1 Mechanical Hazards
Crushing Hazards
The toppling and falling of the microscope may cause injuries to the user. Only operate the micro-
due to Unstable
scope on a stable working table with a solid and smooth tabletop.
Working Table
Property Damage
There is a risk of injury and property damage if the microscope is improperly handled and trans-
due to Transport
ported.
§
Only use the handle to transport the microscope.
2
.3.2 Electrical Hazards
Voltage Hazards
Risk of electric shock in case of contact with live parts.
The microscope must be plugged into a properly installed power socket with protective earth con-
tact using the supplied mains cable. The protective earth connection must not be impaired by the
use of extension cables.
Safe disconnection from the power supply is only ensured by pulling out the mains plug. The
switch on the microscope only switches to standby mode.
Detachable mains supply cords must not be replaced with inadequately rated cords. Always use
the power cords supplied by ZEISS. When an unsuitable power cord is used, ZEISS can no longer
guarantee the electrical safety and functionality of the microscope.
§
§
§
§
Shut down the microscope when not using the microscope.
Disconnect the power supply before cleaning.
Set up and operate the microscope so that the connectors are easily accessible.
Position the microscope in a way so that you can easily unplug the power cable at any time.
2
.3.3 Thermal Hazards
Heat Accumulation
Covering the ventilation openings can lead to heat accumulation that may damage the micro-
scope and, in extreme cases, can cause a fire.
§
§
§
§
Keep ventilation openings unobstructed at all times.
Do not cover devices or openings emitting heat.
Do not obstruct ventilation.
Comply with minimum distance of 30 mm from walls.
Instruction Manual ZEISS Axiovert 5 digital | en-US | Rev. 1 | 431030-7021-101
11
