INSTRUMENT
DESCRIPTION
Carl Zeiss
Instrument Description and Main Features
Cell Observer SD
22
423638-7044-001
M60-2-0021 e 01/2009
2.3
Instrument Description and Main Features
The following components are required for working with the Cell Observer SD with Axio Observer:
−
Microscope Axio Observer.Z1,
−
Laser safety device for microscope and peripheral units consisting of: eyepiece shutter (built into the
microscope), safety distribution box and laser shutter inside the laser module,
−
CSU-X1 laser safety kit,
−
Observer-to-CSU matching parts,
−
Laser module with multi-line argon laser, fiber coupling ports and laser safety components
or
Multi laser module with a maximum of four solid-state lasers, fiber coupling ports and laser safety
components,
−
High-resolution, high-aperture objective lenses, for example Plan-Apochromat 63x/1.4 Oil,
−
PC with working memory not less than 512 MB,
−
Monitor for image display,
−
AxioCam MRm, AxioCam HRm, AxioCam HSm digital camera or Photometrics EMCCD cameras,
−
AxioVision image processing software (Rel. 4.7 or higher),
−
Anti-vibration table or anti-vibration plate for Axio Observer.
Please note that only lasers up to laser class 3B (with 300 mW maximum total output power
within the 450 nm – 640 nm wavelength band) are permitted for operation of the Cell
Observer SD imaging system. Per laser line, the energy must not exceed a level of 100 mW.
You are prohibited from using a laser of greater power. Carl Zeiss MicroImaging GmbH will not
assume any warranty for components of the microscopic system and for maintenance of system
laser safety in such cases.
For connection, use only the fiber that is included in delivery of the scanning disc unit.
The laser power which is injected into the fiber must not exceed a maximum of 100 mW.
Summary of Contents for Cell Observer SD
Page 1: ...l j l pa...
Page 68: ......
