START-UP
Carl Zeiss
Connecting the CSU-X1 Control Box
Cell Observer SD
44
423638-7044-001
M60-2-0021 e 01/2009
3.6.3
Connecting the Filter Wheel
For operation with a filter wheel, the wheel must
also be connected:
•
Connect control cable with filter wheel
(Fig. 3-7/
1
). Secure connector with two screws.
•
Connect control cable to CSU-X1 control box
(refer to section 3.7).
3.7
Connecting the CSU-X1 Control Box
•
Connect terminal
RS232C1
2
) of the
CSU-X1 control box to the computer.
•
Plug the control cable of the CSU-X1 spinning
disc unit into terminal
CSU
1
) of the
CSU-X1 control box.
•
Connect the control cable of the filter wheel (if
installed) to terminal
Motor 1
3
).
•
Connect the line power cable to the CSU-X1
control box (Fig. 3-8/
4
) and a suitable line
power socket.
Do not use terminal jacks of any type
other than specified herein. Disregar-
ding this advice may cause malfunction
of the spinning disc unit.
Fig. 3-7
Filter wheel connection
Fig. 3-8
CSU-X1 control box connection
points
Summary of Contents for Cell Observer SD
Page 1: ...l j l pa...
Page 68: ......
