OPERATION
Carl Zeiss
Switching the System on
Cell Observer SD
52
423638-7044-001
M60-2-0021 e 01/2009
4.2
Switching the System on
4.2.1
Turning the CSU-X1 Spinning Disc
Unit On
•
Switch the microscope on.
Set reflector turret position must be empty!
•
Transfer main power switch of the CSU-X1
control box into
ON
1
).
•
Select a suitable emission filter. Refer to
section 4.6 for details regarding conversion to
another emission filter.
•
Turn the key switch at the spinning disc unit
(Fig. 4-1/
2
) to position
ON
. The green control
3
) will light.
•
Turn the laser on (refer to sections 4.2.2 and
4.2.3).
If the safety device is found to function in a non-conforming manner, you should shut the
system down, clearly mark it as defective and contact the Service Department of Carl Zeiss
MicroImaging GmbH immediately.
Fig. 4-4
Turning the CSU-X1 control box on
Summary of Contents for Cell Observer SD
Page 1: ...l j l pa...
Page 68: ......
