B-0705-1 01/1992 (Digitized 07/2005)
2-5
(7)
Prepare the light
• 12 V/100 W lamp with bayonet
►
circuit
>
(2-8/4) to the tripod back
secure.
• Connectors (2-8/5) on the power supply
Connect (2-8/6).
• With Socket B (2-8/1) the captive
Loosen the mounting screw and the lumi-
tengehäuse (2-8/2) of the light (2-8/3)
decrease.
Figure 2-8 Prepare the light
(8)
Inserting / Replacing the Lamp
• Both Screws (2-9/5), remove
if necessary the lamp.
• Lamp (2-9/4) in the pre-centered support
and secure it with the two knurled
ben clamp first, then the protection
remove cardboard (2-9/3) from the bulb.
NOTE
notch and surface of the lamp carrier
plate must be exactly at both Anschlä-
tions of the lamp receptacle rest.
WARNING
lamp bulb with bare
Fingers touch, possibly the lamp
piston before the first switch with
Clean pure alcohol to a one-
burning of contaminants to
prevent.
Figure 2-9 Inserting / Replacing the Lamp
• Replace the lamp housing (2-9/2) and with
the socket wrench B (2-9/1) tighten.
Page 39
2.1.3 Connecting
Summary of Contents for JENA PLAN HD 9x12
