QUICKSTART
LSM
510
Carl Zeiss
Switching on the System
LSM 510 META
4-12
B 45-0008 e 10/02
−
Start Expert Mode
Use of this mode requires to be thoroughly familiar with the exact microscope procedures and
interrelations.
You need to set all parameters and functions upon your own decision; this mode therefore provides
you with the greatest flexibility of operation.
It is also possible, however, to call up stored configurations and to modify the parameters / settings if
necessary.
After the start of the
Expert Mode
or the
Routine Mode
,
instrument initialization is
performed and can be monitored in the
Initialization
window and interrupted with a click
on the
Cancel
button, if required.
Depending on the selected option (
Scan New
Images
or
Use existing Images
), initialization is
performed in the offline or online mode.
Existing images can only be loaded and processed in the
Expert Mode
.
If you want to change from the
Expert Mode
to the
Routine Mode
and vice versa, close all
the windows first.
Some printers (for example KODAK Thermo Printer) will produce an error message "hard key
not found" in case the printer is not switched on.
Remedy: turn on the printer before starting the LSM 5 software.
Don’t switch off the KODAK printer during the scanning process.
Fig. 4-9
OFF LINE Initialization window
Summary of Contents for LSM 510 META
