LSM 510
OPERATION IN EXPERT MODE
LSM 510 META
Acquire Menu
Carl Zeiss
03/06
B 45-0021 e
4-63
Settings
Add Track
button
An additional track is added to the configuration list. The maximum of
four tracks can be added. One track each with basic configuration is
added, i.e.: one Ch 1 channel is activated, all laser lines are switched off,
emission filters and dichroic beam splitters are set in accordance with the
configuration last used.
Remove
button
The single track previously marked in the
List of Tracks
panel in the
Name column is deleted.
Store/Apply
button
Opens the
Track Configurations
window. A selected track defined in a
Recording Configuration can also be stored as a single track for single
tracking applications. Also, it's possible to load a single track in a
multitracking configuration.
A click on this arrow button will move the selected track (highlighted in
blue) one position upwards in the list box.
A click on this arrow button will move the selected track (highlighted in
blue) one position downwards in the list box.
When adding new tracks, the following sequence should be followed:
•
Add a track by clicking on the
Add Track
button.
•
Determine the configuration of the track in the
Beam Path and Channel Assignment
panel or
select
an existing one via the
Store/Apply Single Track
button of the
List of Tracks
panel.
•
Store the name of a track configuration defined via the
Store/Apply
button of the
List of Tracks
panel. The new track name will then be displayed in the
List of Tracks
panel.
If this way of storing is performed, the created track will also be available as a single track and can
therefore also be activated individually.
•
Add the next track via the
Add Track
button and then configure and store it again.
The name of a track can also be changed directly in the
List of Tracks
panel. In that case, however, the
edited track is not available as a single track configuration, but only within the recording configuration.
To edit a track name within
Recording Configurations,
proceed as follows:
•
To select the track, click on the relevant track name in the
List of Tracks
panel. Then click on the
name again to open the text editing field.
•
Change the track name via the keyboard. Use
Esc
to undo the procedure.
•
Click once in the area outside the text editing box to close this box.
The channels of the individual tracks with the relevant scan parameters can be displayed in the
Scan Control
window after activation of the
Channels
button. The description of channel 1 in
Track 1, for example, is Ch1-T1.
