LSM 510
Routine Mode
LSM 510 META
Application of Examination Methods in …
Carl Zeiss
03/06
B 45-0021 e
6-15
The following functions are available on the right side of the this window:
New Image
button
Opens a new image window.
Start T
button
Starts the time series.
Stop
button
Stops the entire time series. A current scan is canceled.
Pause
button
Interrupts the time series. The button labeling changes to
Resume
. A
current scan is performed until its end. Pressing the
Pause
button again
will resume the time series.
Stage
button
Opens the
Stage and Focus Control
window.
(1)
Start Series panel
Depending on the imported examination method,
the time series can be started and ended manually,
via trigger or by entering a time (computer time).
In the
Start Series & Stop Series
panel, the
relevant mode is displayed. Switching between
manual, trigger and time control is not possible in
the Routine mode.
(a)
Manual start of a time series
•
You can take over the offered parameters by clicking on the
Start T
button.
−
The time series is recorded and displayed in the image window.
•
Click on the
Stop
button to end the time series.
(b)
Starting a time series via trigger
•
The
Start T
button must be pressed first to start a time series via trigger.
−
Waiting for Trigger
will be displayed in the status line.
•
Then the relevant trigger key of the Trigger Control must be pressed to start the first scan procedure
of the time series.
•
The time series is ended by pressing the relevant trigger key.
If the number of cycles entered under
Number
has been processed without a trigger impulse having
been given to end the procedure, the time series is finished.
If a trigger signal is given before the cycles have been processed, the time series will only be interrupted.
Waiting for Trigger
will be displayed in the status line. The time series can now be continued via a new
trigger signal or ended via
Stop
.
Fig. 6-20
Start & End panel
