LSM 510
OPERATION IN EXPERT MODE
LSM 510 META
Acquire Menu
Carl Zeiss
03/06
B 45-0021 e
4-53
4.5.3.1
Open / Close the Configuration
Control Window
•
Click on the
Config
button in the
Acquire
subordinate toolbar.
−
The
Configuration Control
window is
opened with the display last selected.
The
Beam Path and Channel
Assignment
panel differs according to
the hardware configuration supplied.
•
Click on the
Close
button to quit the
Configuration Control
window.
4.5.3.2
Spectra Button
The
Spectra
button opens the
Detection Spectra
& Laser Lines
window. This window displays the
laser wavelengths activated for excitation (as
colored vertical lines) and the activated channels
(as colored horizontal bars).
The color of the bar corresponds to the one
assigned to the relevant channel. Non-active
channels receive a gray bar over the entire spectral
range.
The length and position of the bar corresponds to
the emitted spectral range which is overlaid with
the filter and beam splitters selected in the
Configuration Control
window or number of
selected channels of the META detector.
•
Click on the
Spectra
button to open the
Detection Spectra & Laser Lines
window and
to check the settings you made. The window is
closed via
Close
.
All amendments made in the
Configuration
Control
or
Laser Control
window are updated
on-line in the
Detection Spectra & Laser Lines
window.
•
A click on the
Laser
button enables you to
open the
Laser Control
window, switch lasers
on and off, if required, and control the laser
output.
Fig. 4-34
Configuration Control window,
Single Track activated
Fig. 4-35
Detection Spectra & Laser Lines window
