LSM 710 and LSM 780
CENTER SCREEN AREA / IMAGE CONTAINERS - …
Systems
3D View (Image VisArtplus)
Carl Zeiss
02/2010 M60-1-0025
e
185
All these functions can be used for creating a render series in order to show them and to make
spectacular movies for presentations.
There are three clipping planes, which are labeled for ease of use with colored outlines. These outlines do
NOT represent the channels. The standard orientations of the planes are
blue
: XY plane,
green
: YZ plane
and
red
: XZ plane. This is linked to the default orientation of the volume axis.
Activating the
Clipping
panel displays the clipping planes and displays those with default settings if the
image was not opened in the 3D module before.
is setting back the appearance of the
planes to the following settings:
−
Each plane is placed into the center of the volume and oriented in orthogonal fashion.
−
The planes have an opaque surface and colored outlines.
−
The clipping functionality of the planes is not activated in this state.
Controlling the clipping functionality of the 3
planes
The clipping planes are operated by three buttons
on the
3D
tab which are color coded in the same
way the respective planes are color coded. The
buttons are located below the
Render Mode
Buttons
and can be activated by ticking the
clipping
tick box.
Note that full functionality of the clipping
planes can be found in the
Clipping
View Control
tab!
By toggling these
buttons, the clipping behavior of the planes can be set in the following manner:
−
None:
hides the plane completely
−
Front:
clips away the data on the front side of the plane
−
Back:
clips away the data on the back side of the plane
−
Both:
clips away the data on both sides of the plane
−
Show Plane
only displays the plane – no clipping
Fig. 209
Toggle buttons