CONFOCOR
3
ConfoCor 3
System Configuration
Carl Zeiss
02/2010 M60-1-0025
e
33
•
You can also alter the position by typing into the input boxes or using the sliders or scroll arrows. If
both coordinates are changed, the system will regard this as a new alignment.
In the ConfoCor 3 the pinhole does not move in z. The Collimator for Invisible light is set to the
optimum position in the factory and care should be taken to change its settings. The collimation
for the Visible light is done in the laser coupling and does not need optimization.
Fig. 37
Automatic Pinhole Adjustment in x coarse (left) and x fine
(right)
