128
Preparations
G-30-1529-en
OPMI® VISU 160 on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 09. 10. 2006
Mounting the tube, the eyepieces and the objective lens
•
Bring the suspension arm in a position convenient for you and firmly
tighten locking knob (1).
•
Loosen securing screw (5) by a few turns.
•
Remove cover (3) and store it in a safe place.
•
Place binocular tube (6)
on the microscope body and firmly tighten se-
curing screw (5).
•
You can install further accessories between the binocular tube and the
microscope body. Lock these units in position in the same way using
securing screw (5).
•
Insert widefield eyepieces (8) as far as they will go in mounts (7) in-
tended for them. The magnetic coupling reliably secures them in posi-
tion.
•
Loosen locking knob (1) again and adjust the degree of friction as re-
quired.
Warning!
–
Before every use and after re-equipping the instrument, make sure
that binocular tube (6) is securely locked in position. Make sure that
securing screws (2) and (5) and objective lens (4) have been firmly
tightened!
–
When attaching any components, take care not to damage the Deep-
View system.
–
Re-adjust the balance of the suspension arm after every change of the
equipment.
Note:
If you wish to use documentation equipment, we can supply an eyepiece
with a reticle to aid focusing. The retrofitting of a reticle to an eyepiece can
only be performed in the factory or by our service staff. Always install the
eyepiece with the reticle on the same side of the binocular tube where the
documentation equipment is located.
•
Screw objective lens (4) into the microscope body and tighten it firmly.
