152
Operation
G-30-1529-en
OPMI® VISU 160 on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 09. 10. 2006
Checklist
Warning!
If a function fails, you must not use this instrument for safety reasons. Cor-
rect the fault (see the "Troubleshooting table“) or contact our service dept.
Always check the following points before surgery (without patient!):
–
Check that the correct rated voltage has been set.
–
Check that all cables have been connected.
–
Check that the light guide has been connected.
•
Turn on the system at the power switch of the suspension system.
VISU 160 surgical microscope
Check the zoom function
–
by pressing the appropriate button on the foot control panel.
Check the focusing function
–
by pressing the appropriate button on the foot control panel.
Friction adjustment of the surgical microscope
–
Check that the friction of the surgical microscope's rotation has been
adjusted as required using the friction adjustment knob on the suspen-
sion system.
Speeds of the surgical microscope's functions
–
Check that the speeds of the microscope's functions have been ad-
justed as required on the suspension system.
Eyepieces / binocular tube
–
Check that the surgical microscope and the tube are in a position con-
venient for you.
–
Check that the correct interpupillary distance has been set.
–
Check that the eyecups have been adjusted in such a way that you
can see the full field of view.
–
Check that the correct prescription has been set on the diopter scale.
–
Check that image quality is the same throughout the entire magnifica-
tion range.
Checking the accessories
Using the manuals provided, check that the other equipment (illumination
system, video system, etc.) is functioning properly.
