158
Operation
G-30-1529-en
OPMI® VISU 160 on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 09. 10. 2006
Using the display and key field
General functions
Operating keys "
∇
" and "
∆
"
Keys "
∇
" and "
∆
" always refer to the display field (LCD) on the left, i.e. you
can use them to change the values or settings currently displayed in this
field.
Every time you press the "
∇
" key, the displayed value is decremented in
predefined steps down to a certain minimum.
Every time you press the "
∆
" key, the displayed value is incremented in
predefined steps up to a certain maximum.
Keys "
∆
" and "
∇
" have a repeat function, i.e. if you hold down these keys,
the relevant value is automatically incremented or decremented by the
predefined steps until the maximum or minimum value is reached.
Operating the row of keys
"MODE" key
Press the "MODE" key to switch from the basic mode to the speed mode.
The "MODE" key also brings you back from the speed mode to the basic
mode.
In the configuration modes, use the "MODE" key to return to the basic
mode.
"STORE" key
The function of the "STORE" key is dependent on the surgical microscope
used. For details of the "STORE" key, see the user's manual of the rele-
vant surgical microscope.
"MODE" key and "STORE" key
If you press the "MODE" and "STORE" keys simultaneously, you will get
from the basic mode to the configuration mode 1. If you press the "MODE"
and "STORE" keys simultaneously while you are in one of the configura-
tion modes, the program jumps to the next configuration mode, and from
the last configuration mode back to configuration mode 1, see the illustra-
tion "Overview of user interface".
Note:
If you have selected any of the modes and do not press a key in the key
field, the program will return to the basic mode after 20 seconds.
MODE
STORE MANUAL
USER
1
1
1.5
Basic mode
Halogen
MODE
STORE MANUAL
USER
1
1
1.5
2
1.5
Xe
Xenon
Xenon with hal-
ogen (option)
MODE
STORE MANUAL
USER
1
1
1.5
2
1.5
