ZEISS
1 General Information | 1.2 Explanation on Warnings and Additional Information
1.2 Explanation on Warnings and Additional Information
DANGER, WARNING, CAUTION, and NOTICE are standard signal words used to determine the lev-
els of hazards and risks of personal injury and property damage. Not only the safety instructions
and warnings in the
Safety
chapter are to be considered but also the safety instructions and
warnings in other chapters. Failure to comply with these instructions and warnings can result in
both personal injury and property damage and involve the loss of any claims for damages.
The following symbols and warnings indicating dangerous situations and hazards are used in this
document.
DANGER
Type and source of danger
DANGER indicates an imminently hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING
Type and source of danger
WARNING indicates a potentially hazardous situation which, if not avoided, may result in
death or serious injury.
CAUTION
Type and source of danger
CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor
or moderate injury.
NOTICE
Type and source of danger
NOTICE indicates a potentially harmful situation which, if not avoided, may result in property
damage.
Info
Provides additional information or explanations to help users better understand the contents
of this Instruction Manual.
1.3 Further Applicable Documents
Please take also note of the following documents:
Installation
Requirements
For more details on technical data, refer to the corresponding Installation Requirements.
System and 3rd
Party Components,
Accessories
The Microscope can be configured in many ways. Information about the individual components,
enhancements and accessories can be obtained from your ZEISS Sales & Service Partner. Also refer
to the 3rd Party documentation of the manufacturer.
Software
For more detailed information on how to use ZEN, please refer to its Online Help.
Safety data sheets
Observe the enclosed safety data sheets. The instructions and guidelines given in the respective
safety data sheets must be complied with.
Downloads
, Safety data sheets, ISO certificates, CSA certificates and EU declarations of conformity
as well as software and firmware updates can be found at
https://www.zeiss.com/microscopy/int/
or ask your ZEISS Sales & Service Partner.
Quick Guide ZEISS Primostar 3 | en-US | Rev. 1 | 415501-7012-101
5
