ZEISS
Start-Up and Operation
Primovert
32
415510-7244-001
12/2014
3.3.3.3
Visualization of Data via HDMI Port
The integrated camera can be connected to a monitor, TV or projector for visualization of the live image
data.
The data at the HDMI output is in DVI format. Further HDMI functions (e.g. audio,
communication between monitor and camera) are not supported.
To enable the display the high-resolution images in HD format in this quality, it is
recommended that only HD-capable devices be connected.
•
Connect the monitor / projector to the integrated camera using the HDMI cable.
To do this, insert the HDMI plug (Fig. 20/
1
) into the jack on the reverse side of the microscope
2
) and the monitor / projector (Fig. 20/
3
).
Secure the HDMI plug on the jack on the monitor / projector.
If a monitor / projector is used, an HDMI / DVI adapter cable (Fig. 20/
4
) or HDMI / DVI adapter
will be required for the reproduction of image data.
A default resolution of 720p60 has been set.
•
For further camera settings using the on-screen display menu (OSD) see section 3.3.4.
Live image data can be documented by photo or video recording, see section 3.3.3.1.
•
Connect the integrated camera to the mains supply, see section 3.1.10 on page 27.
The visualized images of the integrated camera may only be used for training and research.
Direct generation of diagnostic results from these image is not proposed.
Fig. 20
Connecting the integrated camera to a monitor / projector
