Blowing pull line into cable conduits (ø 25-200 mm)
Operating Manual EZ300 Version 05/2021
page 13 / 30
7.
How to Use Accessories
Head piece 140 and 200 plus special equipment
For every application, fix connection and head piece corresponding to the interior conduit Ø.
Head piece 140 for Ø 50 to140 mm,
Head piece 200 for Ø 120 to 200 mm
Special equipment for smaller int. Ø from 25 to 50 mm
Shuttle
! First step: blow conduit through without shuttle!
Disk black
-
for normal sequence through all commercial conduits
-
for conduits with deformation, dirt, dust, residues
Disk white
- in case of condensed water or meteor water in conduit
-
possibility for calibration
Parachute
(** see optional accessories)
•
used for heavy soiled conduits and conduits with variations of Ø up to 50 mm
•
occupied conduits might be fed with pull line using an appropriate parachute
Parachute yellow
for int. conduit Ø of 30 to 60 mm
Parachute green
for int. conduit Ø of 60 to 100 mm
Parachute blue for int. conduit Ø of 100 to 150 mm
Parachute violet
for int. conduit Ø of 150 to 200 mm
Cone orange with metallic head
For conduit Ø from 50 to 120 mm, in case of difficult access or frayed conduit end
Air hose 1.8 m
It is helpful in places with very tight clearance or in places lacking enough fresh air. Fix air hose between the head
piece and the blowing connection.
Foam body
Specially designed to feed special pull line in conduits already equipped with cables.
Available for internal conduit diameter of 80, 100, 120, 140, 160, 180 and 200 mm.
Tubulure 40 and 70
Required to apply the foam body to feed special pull line in conduits already equipped with cables.
Tubulure 40 required for foam body sizes Ø 80 to 100 mm
Tubulure 70 required for foam body sizes Ø 120 to 200 mm