Blowing pull line into cable conduits (ø 25-200 mm)
Operating Manual EZ300 Version 05/2021
page 5 / 30
Do not operate the power tool if you are under the influence of any substance (alcohol, drugs) which might impair
visions, dexterity of judgement.
Applications
The EZ300 Pull Line Blower is intended exclusively for blowing in or sucking out special pull lines in pipe work
that has already been laid. Then, cables or extra strong pull lines can be fixed to the pull line in order to pull them
through the pipe work.
It must not be used for any other purpose because of the increased risk of accidents and damage to the machine.
Never attempt to modify your power tool in any way since this may result in accidents or damage to the machine.
Disposal of lines
Used lines can also be used for other purposes of must be properly disposed of. All relevant regulations and laws
of the particular country must be complied with when disposing of old lines.
Personal protective Equipment
Wear proper protective clothing and equipment.
Clothing must be sturdy but allow complete freedom of movement. Wear snug-fitting clothing, an overall
and jacket combination, do not wear a work coat.
Avoid any clothing, scarves, neckties, jewellery or anything that could get into the air intake.
Tie up and confine long hair (e.g. with a hair net, cap, hard hat, etc.)
Wear sturdy shoes with non-slip soles.
Wear safety glasses and ‘personal’ hearing protection, e.g. earplugs or ear muffs.
Fueling
Gasoline is an extremely flammable fuel.
Keep clear of naked flames
,
do not spill any fuel
– do not
smoke.
Always
shut off the engine
before refuelling.
Do not fuel a hot engine
– fuel may spill and
cause a fire
.
Open the fuel cap carefully to allow any pressure build-up in the tank to release slowly and avoid fuel spillage.
Fuel your power tool in a well-ventilated area, outdoors only. If you spill fuel, wipe the machine immediately
– if
fuel gets on your clothing, change immediately.
To reduce the risk of
serious or fatal burn injuries
, check for fuel leakage. If fuel leakage is found, do
not start or run the engine until leak is fixed.
Tighten down the fuel cap as securely as possible. This reduces the risk of unit vibrations causing the fuel cap to
loosen or come off and spill quantities of fuel.