Blowing pull line into cable conduits (ø 25-200 mm)
Operating Manual EZ300 Version 05/2021
page 7 / 30
Vibrations
Prolonged use of the power tool may result in vibration-induced circulation problems in the hands (whitefinger
disease).
No general recommendation can be given to the length of usage because it depends on several factors.
The period of usage is prolonged by:
•
Keeping your hands warm
•
Work breaks
The period of usage is shortened by:
•
Any personal tendency to suffer from poor circulation (symptoms: frequently cold fingers, itching)
•
Low outside temperatures
•
Gripping force (a tight grip hinders circulation)
Continual and regular users should monitor closely the condition of their hands and fingers. If any of the above
symptoms appear (e.g. tingling sensation in fingers), seek medical advice.
Maintenance and Repairs
Service the machine regularly. Do not attempt any maintenance or repair work not described in the operating
instructions. Have all other work performed by a servicing dealer.
ZEITLER AG recommends that you have servicing and repair work carried out exclusively by an authorized
servicing dealer for EZ300. Service dealers are regularly given the opportunity to attend training courses and are
supplied with the necessary technical information.
Only use genuine replacement parts and accessories that are explicitly approved for the EZ300 by ZEITLER AG.
These parts are specifically designed to match your machine model and meet your performance requirements
and also to avoid the risk of accidents and damage to the machine. If you have any question in this respect,
consult an authorized servicing dealer.
Never attempt to modify your power tool in any way since this will increase de risk of personal injury.
ZEITLER AG excludes all liability for personal injury and damage to property caused while using unauthorized
attachments.
To reduce
the risk of injury
from unintentional engine startup,
always shut off the engine and disconnect the
spark plug boot
before performing any repairs, maintenance or cleaning work.
– Exception: carburettor and idle
speed adjustments.
Do not turn the engine over on the starter with the spark plug boot or spark plug removed since there is otherwise
a
risk of fire
from uncontained sparking.
Do not service or store your machine near open flames.
Check the fuel filler cap for leaks at regular intervals.
Use only a spark plug of the type approved by ZEITLER AG and make sure it is in good condition
– see
‘Technical data’.
Inspect the ignition lead (insulation in good condition, secure connection).
Check the condition of the muffler.
To reduce the
risk of fire and damage to hearing
, do not operate your machine if the muffler is damaged or
missing.
Do not touch a hot muffler since
burn injury
will result.
Vibration behaviour is influenced by the condition of the AV elements
– check the AV elements at regular
intervals.
Shut off the engine before dealing with problems.
