Pull line blowing in conduits (ø 18-50 mm)
EZ50 Operating manual version 11/2018
page 10 / 24
5.
Putting into Operation
1.
Before any unit is put into operation, firstly ensure that the device is in
perfect and clean condition and the front plate is clicked on correctly.
2.
Do not work in the vicinity of flammable or explosive materials, fluids, gases or
open flames
3.
In the event of any faults or the suspicion of a fault, disconnect the mains plug
immediately and have the device checked over by the importer or the
manufacturer
4.
Do not blow towards people, animals or objects
5.
If working on a platform or ladder, always carry the unit with the shoulder strap
6.
First blow through the conduit without any line (to clear any water, impurities or
the like in the conduit)
7.
Use protective eyewear (beware of dust, water etc.)
8.
If any residual water is actually left in the ducting, never work in suction mode
(damage to the motor)
9.
Always keep the air intake opening/screen free (danger of overheating/fire). If
any impurities are found in the screen, remove them immediately
10. Never use the device if the mains cable is damaged. Have faulty cables or
plugs replaced immediately (by the manufacturer or the importer). Never pull
the plug out of the mains socket by the cable if your hands are wet. Do not drag
the cable across sharp edges or corners. Never place the cable on hot objects.
11. Caution: some of the plastic parts have limited impact resistance!
Warning!
Improper application, use, modification, operation or maintenance
can lead to serious personal injury or damage to property!
To reduce the risk of personal injury from fire
, never attempt to
suck on hot or burning substances (e.g. smoldering ashes, glowing
cigarettes).
To reduce the risk of fatal
injury from fire or explosion, never attempt
to suck on combustible fluids (e.g. gasoline) or materials soaked in
combustible fluids.
