Pull line blowing in conduits (ø 18-50 mm)
EZ50 Operating manual version 11/2018
page 6 / 24
Applications
The EZ50 Stringing Gun is intended exclusively for blowing in or sucking out special
pull lines in pipe work that has already been laid. Then, cables or extra strong pull
lines can be fixed to the pull line in order to pull them through the pipe work.
It must not be used for any other purpose because of the increased risk of accidents
and damage to the machine. Never attempt to modify your electrical tool in any way
since this may result in accidents or damage to the machine.
Disposal of lines
Used lines can also be used for other purposes or must be properly disposed of. All
relevant regulations and laws of the particular country must be complied with when
disposing of old lines. Lines that have already been used must not be used again in the
cylinder for pull line of the Stringing Gun.
Personal protective equipment
Wear proper protective clothing and equipment
Clothing must be sturdy but allow complete freedom of movement. Wear
snug-fitting clothing, an overall and jacket combination, do not wear a work
coat.
Avoid any clothing, scarves, neckties, jewellery or anything that could get
into the air intake.
Tie up and confine long hair (e.g. with a hair net, cap, hard hat, etc.)
Wear sturdy shoes with non-slip soles
Wear safety glasses and ‘personal’ hearing protection, e.g. earplugs or
ear muffs.
