6.0 PRINCIPLES OF OPERATION
ZEKS Eclipse
TM
90-5,000ZPB Desiccant Dryers
www.zeks.com
13
For dryers equipped with optional Moisture Load Control (MLC) functionality.
Dryer must be equipped with Dew Point Sensor:
MLC:
Press +/- key to activate or de-activate MLC function. Value will
display ON when activated.
MLC Setpoint:
Highlight the value and press ENTER button to choose from
pre-de
fi
ned values.
NOTE: PurgeSync
™
Function is de-activated when MLC function is active.
GENERAL
SETTINGS
SCREEN 3/3
MODBUS RTU:
Controller is con
fi
gured to be a slave.
COM PORT:
Port 1 is dedicated to Communications. For information only
(non-adjustable).
NETWORK ID#:
To set: press Enter Button; use numeric keys to enter
value; press Enter Button to save value.
COMMUNICATIONS
SCREEN 1/4
6.9.8 COMMUNICATIONS
Establish remote communication settings.
For information only (non-adjustable).
TIMEOUT:
Default - 1 seconds.
RETRIES:
Default - 3 attempts.
DELAY:
Default - 10 minutes.
COMMUNICATIONS
SCREEN 2/4
BAUD RATE:
Press Enter key to highlight
fi
eld. Press +/- to select from
preset values.
DATA BITS:
Default - 8. For information only (non-adjustable).
PARITY:
Default - None. For information only (non-adjustable).
COMMUNICATIONS
SCREEN 3/4
STOP BITS:
Default - 1. For information only (non-adjustable).
IP ADDRESS:
Press +/- key to access Setup Screen.
COMMUNICATIONS
SCREEN 4/4
IP ADDRESS:
Default - 192.168.192.10. To change number, use UP/
DOWN Navigation Keys to position Cursor where change is needed, press
Enter key, use Numeral Keys to enter 3 digit number, press Enter to save.
SUBNET MASK:
Default - 255.255.255.0. To change number, use UP/
DOWN Navigation Keys to position Cursor where change is needed, press
Enter key, use Numeric Keys to enter 3 digit number, press Enter to save.
DEF GATEWAY:
Default - 192.168.192.254. To change number, use UP/
DOWN Navigation Buttons to position Cursor where change is needed,
press Enter Button, use Numeral Keys to enter 3 digit number, press Enter
to save.
COMMUNICATIONS
SCREEN 4/4
(Setup)
