Zelmer ZCK8020B, User Manual

9

8

PL

PL

EN

EN

-staff kitchen areas in shops, offices and other working 

environments;
-farm houses;
-by  clients  in  hotels,  motels  and  other  residential  type 

environments;
-bed and breakfast type environments.
Never immerse the appliance in water or any other liquid.
If the kettle is overfilled, boiling water may be ejected.
Appliance is only to be used with the stand provided
Warning: avoid spillage on the connector
Warning: potential injury from misuse!
Heating element surface is subject to residual heat after 

use.
Allow the kettle to cool completely before cleaning.
Always remove the plug from the mains before cleaning 

the kettle.
Do  not  use  any  abrasive  cleaning  agents  –  such  as 

emulsions, creams, pastes, etc. – for cleaning the kettle.
This appliance is intended for use at a maximum altitude 

of 2000m above sea level.

IMPORTANT WARNINGS

Any incorrect use or improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the 

product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not use the device, or connect and disconnect to the supply mains with the hands and / or feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle.
Only fill the kettle with water. Milk and instant beverages will burn and damage the appliance. Never operate 

the kettle without water and do not over fill it; observe the min and max markings. If the kettle is too full, the 

water will boil over!
Do not put the jug on a stove or in a microwave for re-heating of water.

Always place the kettle on a stable, smooth, flat surface; the power cord must not hang loosely off the edge 

of a table (or any other work surface) or touch a heated surface.
Do not use the kettle with the lid open.
Do not remove the lid when the water is boiling.
If the internal  electrical  elements are flooded  with water, make sure the kettle is completely  dry before 

plugging in.
Do not move while the kettle is switched on.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact 

an official technical support service. In order to prevent any risk of danger, do not open the device. Only 

qualified technical personnel from the brand´s Official technical support service may carry out repairs or 

procedures on the device.

B&B TRENDS SL. 

disclaims all liability for damages that may occur to people, animals or objects, for the 

non-observance of these warnings.

INSTRUCTIONS FOR USE

Before use

Make sure that all the product’s packaging has been removed.
Before heating water for the first time, we recommend using the kettle twice, in order to clean the system.

Boiling water

Fill the kettle with fresh water through the open lid (press lid release button)
Read the quantity on the water level indicator. Do not fill less than the minimum and maximum marks
indicated.
Close the lid until it locks and place the kettle on the base.
Press the switch down, the switch turns on. If the kettle has led light, it will turn on. The water is heated.
The kettle switches off automatically once the water is boiled.
The appliance can also be switched off at any time by pulling up the ON/OFF switch.
Warning: If you remove the kettle from the base and replace it before the heating process is over, the
kettle will continue to heat the water.
Only operate the kettle with the lid closed.
After boiling, let the kettle cool down for 5 minutes before refilling it with water.
Do not turn on the appliance if the kettle is empty, otherwise the overheat control will engage and the
appliance will switch itself off automatically.

MANITENANCE AND CLEANING

1. Do not forget to remove the plug from the socket before cleaning the appliance.
2. Wipe outside with soft dry cloth when the kettle is wet, never use metal polish.
3. Never use a dishwasher to clean any parts from the machine.
4. Rinse the kettle and the limescale filter with clear water
5. Put the water kettle in a dry and not very hot place.