76
GW39-002_v05
Handling and operation of hair clipper
The hair clipper can be used both as a mains supplied or cordless device.
1. Operation with power supply adaptor
●
At first insert the adaptor plug into the device and then insert the adapter plug into the
mains supply outlet (230 V). In mains supplied mode the device is ready for use.
2. Loading accumulators and cordless operation
Load the device minimum 16h before first usage and when 2–3 next
loadings.
●
In order to load the device move the ON/OFF switch
(4)
to „0”position.
●
Place the device on the loading base
(II)
.
●
Connect the loading base
(II)
to the adapter cord
(III)
.
●
Insert the plug of the power adapter
(III)
into appropriate mains supply outlet (230 V).
The charging process is indicated by red pilot light
(5)
glowing.
●
Once the battery is fully charged, the pilot light will change from red to green.
●
When fully charged the hair clipper can operate for approximately sixty minutes.
●
The hair clipper battery obtains optimum power after three cycles of charging and
discharging. Ten hours is enough for next charging. In order to provide long battery life,
it should be fully discharged before recharging.
3. Using the clipper for hair cutting and thinning
Cut the hair for demanded length in stages, start form bigger length.
●
Insert appropriate comb attachment (small
(IV)
or big
(V)
).
●
Set the desired length of hair/beard with the cutting length adjustment knob
(3)
.
The length of clipped hair is indicated (In millimetres) at the length indicator on the
comb attachment.
●
Switch the device on moving the ON/OFF switch
(4)
to 1 position.
●
Cut only small areas.
●
Move the clipper slowly along hair.
●
Hold the device so, that the comb attachment is laid flat.
●
Always start the cutting from the neck upwards or from the forehead and temples
upwards to the top of head.
