ATTACHING THE WALL
Use the steps below for both the solid wall and mesh wall.
NOTE: Only one wall can be zipped on at a time.
1. Lay the wall out flat in front of your tent.
2. On the left side (facing the front of the tent) attach the zip end through both zipper sliders on
the tent.
3. Pull the zipper closed, lifting the wall as you go to reduce tension on the zipper.
4. Peg out the front corners of the wall so that the panels are evenly tensioned.
NOTE: To make the front door easier to access, the “anchor webbing Y-strap” can be converted to
a single strap. To do this, unclip the outer buckle on the Y-strap and secure the outer side using
the clip located below the inner side’s buckle. You may need to adjust the angle and tension of
the anchor webbing to suit this single strap configuration.
USING THE SOLID WALL AS AN AWNING
It is possible to attach the solid wall as an awning to provide additional shade and shelter. This is
possible with or without the mesh wall attached (see front page).
1. First attach the buckles at the top of your Awning Wall to the corresponding buckles on the
front of the tent found between the front tube and awning valance.
2. Remove the two “anchor webbing Y-straps” from the front of the tent.
3. Attach each anchor webbing strap to the corresponding buckles on the bottom of your wall. To
convert your Y-strap to a single anchor strap, you will need to secure one side of the Y-strap to
the clip located below the inner side’s buckle.
4.
Assemble the awning poles:
Evo TXL Wall Poles = 2 x 3 Long Sections, 1 x 4 Short Sections
Evo TL, Evo TM/TS Wall Poles = 2 x 3 Long Sections
5. Insert an awning pole through each eyelet on the awning wall.
6. Peg out and adjust the webbing straps to tension the wall/awning.
NOTE: For extra shelter, attach a guy rope to the steel ring on each side of the awning wall and
tension. The TXL Wall will also require an additional guy rope for the center awning pole.
Evo TM/TS
V2
Awning Wall Set – Mesh Wall
Evo TM/TS
V2
Awning Wall Set – Solid Wall
Anchor Webbing
CARE INSTRUCTIONS
1. Ensure guy ropes are out at all times during use.
2. Never pack your shelter away wet. If you must take your shelter down when wet, ensure that it
is dried completely as soon as possible to prevent mildew forming.
3. If mildew does form on your shelter, wash off with warm water and a soft brush to prevent
further growth. Do not use soap or detergents.
4. Do not use aerosol spray cans or an open flame inside your shelter. The fabric has been treated
with a fire retardant but is in no way fire-proof.
5. Always use a peg puller to remove pegs. Never remove pegs by pulling the shelter or peg loops;
always clean and dry pegs before storing.
6. This shelter is not designed to withstand storm conditions. During a severe storm, it is
recommended that the shelter be taken down.
7. Do not leave your shelter pitched unnecessarily for extended periods of time. UV light damages
the fly and will shorten the life of your shelter.
GALLERY
VIDEO
TO THE
ZEMPIRECAMPING.INFO/VIDEO-GALLERY
Evo TM/TS
V2
Awning Wall Set – Awning with Mesh Wall
Evo TM/TS
V2
Awning Wall Set – Awning
NEED HELP WITH
YOUR TENT?
We have a range of videos on
our website which can help you.
Follow the QR code or type the
link below in your browser. We
suggest to check out our videos
beforehand in case you don't have
service at your holiday destination.