8
5
9
INSTALLATION:
5. (No picture)
Fit the GPS antenna (No. 3) at a suitable place,
and make sure that the GPS reception is not
adversely affected due to shadowing by metallic
vehicle parts (thermal glazing etc.). Next run the
connecting cable to the radio slot.
6. (No picture)
If you wish to use it, now fit the external Blue-
tooth microphone (No. 4) supplied, and run the
connecting cable to the radio slot. Depending
on preference and on choice of an external or
device-internal microphone, the microphone
source for the Bluetooth mode must be corre-
spondingly changed in the device menu.
7. (No picture)
Run the USB extension cable (No. 9) from the
radio slot to the position you want.
8. Connect one of the main connection cables
(No. 5 or No. 6) of the ZENEC system (No. 1) to
the Quadlock connector of the car and close its
locking mechanism. Please pay attention to the
compatibility list in this document to choose the
suitable main connection cable, including in the
delivery, for your vehicle. Following this, connect
the CAN bus interface (No. 7) to the main con-
nection cable.
9. Before installing the ZENEC system (No. 1)
remove the two transport securing screws.
