6
10
11
12
COMMISSIONING
Make sure that the vehicle is located outside, and that the GPS reception is not adversely affected by any
shadowing (trees, high buildings etc.). Now insert the navigation software SD card (No. 2) supplied into the
microSD card slot of the ZENEC system, and start it in order to establish a sat fix. Make sure that the vehicle
is not moved until the sat fix is established. Now press the NAV button to start the navigation mode, and
choose map view. Once your present location can be seen in the map view the sat fix has been established.
This can take 3 to 5 minutes. You can now use the ZENEC system.
Finally carry out a general functional test and perform the basic and car specific settings (AC, OPS etc.).
Also ensure that no fault warnings appear on the vehicle side.
12. Press the trim frame back on to make the instal-
lation complete.
●
Make sure that all connectors at the rear of the ZENEC system have sufficient room and are not bent.
● Connectors without a retaining mechanism must be additionally secured with insulating tape.
● If the navigation arrows are not present in the multi-functional display MFA+, although the needed
data are available via the CAN bus system, you have to unlock them first. Please contact a qualified
specialist workshop in such a case. Inappropriate actions can cause damage to the vehicle and
the ZENEC system.
11. Neatly arrange the wires to the side, making
room for the ZENEC system. Carefully slide it
into the radio slot and fix it in place, using the
four original Torx screws.
10. Connect all the cables to the ZENEC system
(No. 1): those previously run in the radio slot,
and the original antenna cables.
NOTE
