68 Rev.B
69 Rev.B
REMOVAL WORK AND PREPARATION
INSTALLATION NOTES
NOTE
● Make sure that all connectors at the rear of the ZENEC system have sufficient room and are
not bent.
● Connectors without a retaining mechanism must be additionally secured with insulating tape.
CAUTION
● The installation of the ZENEC system should be carried out by an authorized installer. Specific
knowledge and tools are required to do the installation. Incorrect installation can cause damage
to the vehicle and the ZENEC system.
●
Correct functioning can only be guaranteed when you use the ZENEC original accessories
included in the kit or those optionally available. The ZENEC system and the original accessories
must under no circumstances be modified or altered in any way. Inappropriate actions can
cause damage to the vehicle and the ZENEC system.
NOTE
●
The ZENEC system is not compatible with vehicles, which are equipped with a hybrid or electro
drive ex factory.
●
The ZENEC Z-N528 is equipped with an integrated DAB+ receiver. To make use of this you
will need a suitable DAB antenna (not included in kit) that must be connected to the ZENEC
system.
●
If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it
in combination with the ZENEC system.
●
Software updates to the ZENEC system are installed with a USB memory device. Therefore
when fitting the system make sure that the USB connection of the ZENEC system will still be
accessible later (installation of USB extension cable or USB hub).
●
If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
NOTE
1. Remove the ignition key and keep it outside the car until the installation is finished.
2. Please wait for ca. 10 minutes until the CAN bus system is completely shut down, before
you start with the deinstallation of the original device.
3. Start with the deinstallation of the original device.
4. Please switch on the ignition only, when all work steps are done and the ZENEC system is
completely mounted.
OVERVIEW INCLUDED
ACCESSORIES
No. Article
Qty
1 Main device user manual
1
2 2DIN trim frame
1
3 2DIN metal device mounting cage
1
4 ISO-DIN main harness
1
5
Bluetooth microphone with mounting clip
1
6
Factory radio removal tool
1
7
Parking break wire
1
8
USB
extension cable
2
9
A/V IN / Video IN / eCall Mute
1
10 Camera 1 & 2 / Reverse Signal / Steering Wheel Control interface (IR-IN)
1
11
4.2 RCA preamp line out / Subwoofer
1
12
Video OUT
1
