7
rougher. This can be avoided by subtle movement of the sander back and forth when
grinding or polishing. Sander movement will become smoother as the paper will wear
out.
Maintenance anD inspection
1. Emptying and cleaning the dust bag
If the dust bag contains too much saw dust, dust collection will be affected. Empty the
dust bag when it gets full. Remove the dust bag, open the fastener, and dispose of the
contents.
2. Inspecting the sanding paper
If the dust bag contains too much saw dust, dust collection will be affected. Empty the
dust bag when it gets full. Remove the dust bag, open the fastener, and dispose of the
contents.
3. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
4. Maintenance of the motor.
The motor unit winding is the very “heart” of the power tool. Exercise due care to
ensure the winding does not become damaged and/or wet with oil or water.
4. Maintenance
In case of malfunction of power tool consult an authorized technical service agent.
CAUTION
When using the screwdriver follow these rules:
• continuous use of the power tool should not exceed 15 minutes;
• do not allow mechanical damage (strikes, falls etc.);
• protect the power tools from external sources of heat and chemically active substanc
-
es, as well as liquid and objects penetration;
• before disconnecting the tool from the power source turn off the On/Off switch;
• check the engine temperature, do not allow overheating;
• change the rotation direction only after switching off the tool and complete stop of
rotating parts.
Inobservance of these rules will make warranty void!
WARNING
Repair, modification and check of ZENIT power tools should be performed only in
