Page 2
Zenith Soap Dispenser- Installation & Operating Instructions 87401NZ - June 2008
1. Check if surface of wall is
smooth and clean.
2. Note the distance between
two dispensers or from wall
must be >=20cm.
3. Distance between sensor and
bench-top should be
>=25cm.
4. If distance is <25cm, check
suitability and sensor
adjustment as per Fig. 10.
Dimensions
W x H x D
120 x 265 x 113 mm
(4.7” x 10.4” x 4.4”)
Soap Tank
Capacity
800ml
Battery
6pcs of alkaline AA (1.5V)
or 1pc of Alkaline (9V)
battery. (Not Included)
Pre-set Sensing
Range
11.5±2 cm (adjustable)
Room
Temperature
5ºC~40ºC
Sensing Delay
Time
0.5 ~ 1 sec
Dispensed Soap
Quantity
about 1.0~1.5 ml
Applicable Liquid
Soap Viscosity
0.5 ~ 35 dPa*s
1. SPECIFICATIONS :
2. PACKING LIST :
4. BEFORE INSTALLATION :
ITEM
DESCRIPTION
KIT NO.
1
ELECTRONIC BOX W/ BATTERY COVER KIT
99151
2
BATTERY BOX KIT
99152
3
SOAP TANK + TUBE KIT
99153
4
TUBE (FOR SOAP TANK) KIT
99154
5
KEY KIT
99155
6
LOCK KIT
99156
SPARE PARTS KIT LIST :
SOAP TANK COVER
1. Paste the Installation Template at the
appropriate location on the wall.
2. Drill two ø6mm holes and insert plastic
dowels. (Fig. 1)
3. Insert two screws into dowels and tighten.
Leave about 3mm gap between the screw
and the wall to hang the soap dispenser.
(Fig. 2)
7. Tighten the screws. (Fig. 4)
8. Put the soap tank back into the housing and
close casing. (Fig. 5)
9. Use key to lock casing. (Fig. 6)
BACK
PLATE
ELECTRONIC BOX
SOAP TANK
CASING
LOCK + KEY
BATTERY
BOX
LED
BATTERY BOX
COVER
BATTERY BUTTON
25cm
4. Remove the soap dispenser casing using the
key to unlock. (Fig. 3)
5. Remove soap tank.
6. Hang soap dispenser on the screws.
Fig. 1
Fig. 6
25cm
20cm
3. STANDARD INSTALLATION :
5. INSTALLATION STEPS:
6mm
Fig. 2
Fig. 3
Fig. 4
Fig. 5
TUBE
Illustration
Description
Qty
1
Soap
Dispenser
1 Set
2
Installation
Instruction
1 Pc
3
Installation
Template
1 Pc
4
Key
1 Pc
5
Plastic Dowel
2 Pcs
6
Fixing Screw
2 Pcs
