Filter Tap - Installation & Operating Instructions - 801085NZ - January 2013 v1.00
Page 5 of 8
# Filter
Replacement
Not changing cartridges when required may cause the water to become biologically unsafe.
Thoroughly flush the water through if the filter tap has not been used for more than 12 hours. For safe operation, the
filter cartridge should be replaced at least every 6-12 months, or earlier if you notice a persistent reduction in water
pressure from the Filter Tap, or an unpleasant taste or odour in the water.
Use only a Zenith filter cartridge to match that of your Filter Tap. Replacement cartridges can be obtained through
plumbing suppliers or directly from Zenith.
When replacing your Zenith filter cartridge, replacement instruction will be provided with your replacement cartridge kit.
Operating
You can obtain filtered water within the rated capacity for as long as you rotate the
lever. In the upright position the tap is off, when the lever is rotated anticlockwise
water will flow. Water will continue to flow until the lever is returned to the upright
position.
Cleaning
Never use strong, corrosive or abrasive cleaning materials on the Zenith Filter Tap.
Wipe the outer surfaces clean with a sponge or a soft cloth using a mild soap and
water.
ROTATE
# Operating
Procedures
Problem
Cause Remedy
No water at outlets
Water not connected
Connect and turn on water
Poor flow at outlet
Blocked filter
Replace filter
Troubleshooting
#
Installation Instructions
NOTE:
When flushing the system, some black particles may be released into the water. This is normal. The water will
become clear after the first few litres.
Complete the installation and leave these instructions with client.
Service
All service work must only be carried out by a suitably qualified and experienced service person.
Before calling for service, check the water supply is turned ‘ON’ and OK.
Call Zenith on 0800 558 055 for assistance, service, spare parts, or enquiries.
