Page 61
Remote Control Auto Find
If Programming the Remote did not find the code, try this procedure to
automatically find the code for the device. If the remote becomes inopera-
ble, go back to “Programming The Remote” and enter the Zenith TV code for
Step 5, see page 60.
Turn the device On you’re programming the
remote control to operate.
Press and hold the PRG key 2.5 seconds
until the Red LED indicator light stays on.
Press the key for the device you’re trying to
program (CABLE, VCR, AUX, TV). Red LED
will blink.
Press Channel Up or Channel Down to send
a power On/Off code. Red LED will blink
with each press. Repeat until the device
turns Off. (This is a trial and error process,
so it may be necessary to repeat these
steps until the remote finds the code.)
Press ENTER to save the code. Red LED will
blink twice and exit search mode.
Press POWER to turn the device back on.
You can quickly get out of Auto Find by
pressing QUIT.
If the indicator light stays On while you
push Power, instead of turning Off, all the
codes have been tried and the device can’t
be programmed.
1
2
3
4
5
6
PRG
POWER
CABLE
VCR
AUX
TV
AUDIO
FLASHBK
MUTE
CHANNEL
CHANNEL
VOLUME
VOLUME
1
2
3
4
5
6
7
0
8
9
MENU
REWIND
FFWD
RECORD
A
B
C
CC
TV/VCR
SOURCE
PAUSE
TIMER
PLAY
STOP
ENTER
4
5
2
Red LED
3
6
4
