P A G E 4 2
206-3602-O
PRG
POWER
CABLE
VCR
AUX
TV
SURF
ENTER
FLASHBK
MUTE
CHANNEL
CHANNEL
VOLUME
VOLUME
1
2
3
4
5
6
7
0
8
9
MENU
REWIND
FFWD
RECORD
QUIT
A
B
C
CC
TV/VCR
SOURCE
PAUSE
TIMER
PLAY
STOP
5/7
3
6
2
4
Indicator Light
Remote Control Auto-Find
Turn on the device you’re programming for the
remote control.
Press and hold the PRG key until the indicator light
turns on.
Press the key for the device you’re trying to program
(CABLE, VCR, AUX, TV).
Enter the code 0-0-0 (zero-zero-zero), then press the
ENTER key right away.
Aim the remote at the correct device and press
POWER. Allow a second to pass, then push the
POWER key again. Repeat until the device turns off.
(This is a trial and error process, so it may be neces-
sary to repeat these steps until the remote finds your
code.)
Push ENTER to save the code.
Press POWER to turn the device back on.
1
2
3
4
5
6
7
You can quickly get out of Auto Find by pressing QUIT.
If the indicator light stays on while you push Power, instead
of turning off, all the codes have been tried and the device
can’t be programmed.
If Programming the Remote did not find your code, try this procedure to automatically find
the code for your device. If your remote becomes inoperable, go back to “Programming your
Remote” and enter the Zenith TV code for step five
