Programming the Remote to Operate Other Devices
31
The remote control for your projection TV is a multi-brand or
universal remote control. It can be programmed to operate most
remote-controllable devices from other manufacturers.
Note that the remote control may not control all models of other
brands.
1. Test your remote control.
To find out whether your remote control can operate the IR device
without programming, turn on the IR device such as a VCR and
press the corresponding mode button (VCR) on the remote
control, while pointing at the IR device. Test the POWER and CH
+/- buttons to see if IR device responds properly. If not, the remote
requires programming to operate the device.
2. Turn on the IR device to be programmed, then press the
corresponding mode button on the remote control.
3. Press the POWER and MUTE buttons simultaneously, the remote
control is ready to be programmed for the code.
4. There are two ways to find the right code for the IR device.
A. If you press the CH +/- buttons repeatedly, the codes will
change one at-a-time. Press the POWER button after each code
change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the remote.
Programming code numbers for the corresponding component
can be found on the following pages. Again, if the code is correct,
the device will turn off.
5. Press the EXIT button to store the code.
6. Test the remote control functions to see if the IR device responds
properly. If not, repeat from step 2.
1
2
3
4
5
6
7
8
9
0
tv
vcr cable dvd sat
mode
light
power
tv/video
dvi
comp
avl
cc
arc
enter
video
audio
vol
ch
sleep
mute
mts
fcr
menu
exit
still
flashbk
record
stop
pause
rew
play
ff
skip
right
enter
left
down
up
3/4
4
2
3
4
5
Summary of Contents for R40W46F Series
Page 38: ...Notes 38...
Page 39: ...Notes 39...
