/M Monochrome display. The display screens are shown using
monochrome attributes, even on a color display. The default
is to display color, unless a monochrome video display is
detected. Use this parameter when you have redirected the
console to one of the onboard serial ports.
/N
Modeling mode. Lets you open an existing SCI file or create
a new one. If you use this parameter, the configuration is
saved to a named SCI file rather than to the flash memory.
/P
Permanent command interpreter. Indicates that there is no
COMMAND.COM and the ECU is to reboot the system
instead of exiting to the operating system. The ECU prompts
you to press a key to continue with the reboot.
Other ECU Configuration Utilities
One of the selections from the main menu of the ECU, Access
System Utilities, lets you set system passwords and other
configuration settings. Some of these settings are also accessible
through Setup.
Password Utilities
Power-on Password — If you set a password in this utility, it
must be entered each time the system boots before you can access
the system. To disable the password facility, set the
clear-password jumper on the system board. Refer to the
“Jumpers Configurations” section later in this chapter.
To enter a power-on password, follow the instructions on the
screen. The next time the system boots, it will prompt you for the
password.
To change the password, enter the following at the
Enter Password
prompt:
oldpassword/newpassword/newpassword
To remove the password, enter the following at the
Enter Password
prompt:
password/
04/APRIL/93 – 595-5484-UU
34
3-12
Configuring Your System