Note: If you are installing a SCSI device, please be certain
that you are using the 50-pin SCSI data cable. This cable
comes from the lower drive bays to the space behind the
externally accessible bays and terminates on the front panel
board. Do not confuse this cable with the 34-pin floppy disk
drive cable which begins on the system board and terminates
on floppy disk drive A in bay A.
10. Position the device so that the plastic slide rails on each side
of the device engage the peripheral bay guide rails.
11. Push the device into the bay until the slide rails lock in place.
12. Remove the peripheral filler panel from the front panel by
removing the two screws that hold it in place.
(F4-27 548400031)
13. Replace the front panel and covers, and power on the system.
14. It may be necessary to run the ECU as described earlier in
this chapter.
04/APRIL/93 – 595-5484-UU
98
4-44
Upgrades and Options
