Zenith ZB410B, Owner'S Manual

6

7

Setup, cont.

Write your codes down here for easy reference later.

Code Search

If your product does not respond after you have tried all 
the codes for your brand, or if your brand is not listed, 
try searching for your code by following these steps.

1.  Manually turn on the device (TV, SAT, etc.) to be 

controlled.

2.  Press and hold the 

SETUP 

button until the red 

indicator stays on, then release the 

SETUP 

button.

3.   Press and quickly release the desired mode button 

(

TV

, 

SAT

, etc.). The red indicator blinks off once.

4. Press the 

CHANNEL UP

 button repeatedly (up to 

300 times) until the device to be controlled changes 
channel. The red indicator blinks off with each 
button press.  If you accidentally overshoot the code 
required, press the 

CHANNEL DOWN 

button 

to backtrack through the library until the device 
changes channel. Pressing 

CHANNEL UP

 changes 

direction to forward again. 

5.  Press and release 

MUTE 

to install the code. 

Most users will store SAT codes under the 

SAT 

button, 

Cable codes under 

CBL

, etc. If (for example) you want 

to store a VCR code under 

CBL

, fi rst follow the proce-

dure for Direct Code Entry (previous page) and press 

CBL 

in step 2 of Direct Code Entry, then enter ANY 

VCR code in step 3 of Direct Code Entry. Then fol-
low the steps above for Code Search (or Brand Search, 
below). 

Note

:  If the device does not have a

 CHANNEL 

UP

 button, use 

PLAY 

(VCR only) or 

POWER 

instead. 

Code Search starts from the currently stored 4 digit 
number under that mode.

Setup

Battery Installation

1.  On the back of the remote, push down on the tab and 

lift the cover off.

2.  Match the batteries to the + and - marks inside the 

battery case, then insert 2 AAA Alkaline batteries.

3.  Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are 
depressed more than 30 seconds. 

Code Saver

You will have up to 10 minutes to change the batteries 
in your remote without losing codes you have 
programmed. However, do not press any buttons until 
batteries are installed in the remote. If buttons are 
pressed without batteries in the remote, all codes will be 
lost.

Direct Code Entry

NOTE: You can store any kind of code under any mode 
(except TV). I.E. you can store a VCR code under the 

CBL 

button, or a DVD code under the 

SAT 

button, etc. 

However, you can only store TV codes under the 

TV 

button.

1.   Press and hold the 

SETUP 

button until the red 

indicator stays on, then release the

 SETUP 

button.

2.   Press and release the desired mode button (

TV

,

SAT

, etc.). The red indicator blinks, then stays lit.  

3.  Enter the 4 digit code from the code tables (on 

separate sheet). Note: after a valid code entry, the 
red indicator turns off.  For an invalid code, the red 
indicator fl ashes.

4.  With your device on, press

 CHANNEL UP

. If 

the device responds, no further programming is 
required. Note: If some buttons do not operate your 
equipment, try one of the other codes for your brand.

Type Type 

stored 

Code

TV

DVD/VCR

SAT

CBL